Cedar garage door restoration

Restoring a cedar garage door isn’t just about making it look good again; it’s about reviving the timber, protecting it from future damage, and ensuring it lasts for years to come.

We start by removing years of built-up dirt, mould, dead timber fibres, and weathered coatings using a specialist timber cleaning solution. This eco-friendly formula lifts out contaminants and prepares the wood for restoration, ensuring the best possible adhesion for staining. If left untreated, these elements can cause premature rot and deterioration, so this step is crucial.

Once clean, we carefully sand the cedar surface to remove any remaining old coatings, faded layers, or surface imperfections. This exposes fresh, healthy wood underneath while smoothing out the grain. Sanding also opens up the timber’s pores, allowing for better penetration of the oil stain and deeper protection.

Instead of traditional varnishes that can crack, peel, and trap moisture, we use a high-quality penetrating oil stain. This specially formulated stain:

• Enhances the natural colour of cedar, restoring its rich, warm tones.
• Deeply penetrates the timber, protecting it from moisture, UV rays, and future fading.
• Allows the wood to breathe, preventing mould buildup and ensuring a longer-lasting finish.

We carefully apply multiple coats as needed, ensuring even coverage and long-lasting protection. Once the stain has fully cured, your garage door will look as good as new, if not better!